A project which uses an arduino, pump, and soil moisture sensor to create an automatic watering system for my lily plant. So far I've
A hardware project to turn a Raspberry Pi into a small synthesizer and sequencer. So far I've set up the Pi for remote access, learned the Linux terminal, written my first Python scripts, and wired a row of push buttons to the Pi's GPIO pins on a breadboard, and created some sounds with the buttons. Next, I'm writing code for the synthetizer and am also planning to design a small case on solidworks and 3D print it.
Tools: Python, Raspberry Pi 4
A SolidWorks design for a quadcopter payload system that delivers and retrieves a 3 lb water payload, drafted for the VFS DBVF 2026-27 competition. The drop targets are small, so for a draft I chose a tether design that lowers the payload precisely, instead of dropping it from altitude.
I'm designing a push-in plug-and-socket lock, a plug on the rope pushes into a funnel on the lid and latches with a ball lock mechanism, which a servo releases. So far I've modeled the body of the payload and the lid funnel which will be attached to a rope on the drone.
This years RFP: https://vtol.org/files/dmfile/v1_vfs_dbvf_rfp_2026-2027.pdf
Tools: SolidWorks.
Worked with 1 other teammate to design and built a thrust stand to measure the thrust of our propellers. I designed the CAD model, and helped assemble it
Challenges: We had a hard time figuring out how to minimize cost, to solve this, we made the base plywood and used extrusions only when necessary. We also needed to figure out how mount our metal extrusions (which would hold the propeller) onto the aluminum rod neatly without drilling any holes. I designed a holder that was able to attach to the extrusions securely and attach to the aluminum rod.
Tools: Solidworks
1st draft - based on UAV Forge's thrust stand